https://doneganlandscaping.com/wp-content/uploads/2020/08/Peter-Donegan-Garden-Design-1030x213.png 0 0 Peter Donegan https://doneganlandscaping.com/wp-content/uploads/2020/08/Peter-Donegan-Garden-Design-1030x213.png Peter Donegan2010-01-29 06:37:332013-04-10 15:50:29How To Stake And Strap A Tree
Following the pictures above…..
- tree stake at the ready… place the stake [generally] 3 fingers width from the base of the tree and 2 fingers width from the top. Once you have your position correct… push it in slightly.
- A tree stake pounder [the yellow object in the photographs] is preferable although you can use a sledge hammer. I find the sledge more often splits the stake and its also not very nice for Mary if she is the one holding it and you miss 😉
- Drive your stake in until it’s sturdy, whilst along the way making sure its straight as it goes down.
- There are many forms of straps and buckles available… but for my garden I generally but a roll of strap and cut to size. Always allow a little extra if you are unsure you can always cut a little bit off the end – you can’t however add a little bit on.
- Wrap your strap around the tree and add the buckle on. Then pull really tight against the tree…. wrap one side around the stake and then double over the first piece.
- With the tree now sturdy against the stake and the strap not moving…. get Mary [or someone else 😉 ] to lean agains the back of the stake and hammer a nail in. Always leave a little off the nail sticking out so it can be removed if you get it wrong or it needs to be adjusted in time as the tree grows. Be sure not to tie the tree too tight.
- If you are doing trees in straight lines and you wish for them all to look nice and neat…. take a cane as an optimum measure of height, mark the tree stake and saw off at an angle.
- A little tidy around the base and go and grab yourself a cuppa 🙂